Splashback Alu-Dibond Impressions of New York City

 

Please note it is not possible to influence the direction of the brushed surface

 

 

Good to know: You can tailor the kitchen wall panel easily to a size you wish. Use a steel ruler and a sharp knife. Cut the wall panel from behind to prevent any scratches on the frontside. Please do note: cutting the kitchen wall panel is at your own risk. We can not accept liability for cutting errors. 

 

 

There are three different options for you to install the kitchen wall panel. You can order the required accessories as a complementary product. It is important to prepare the installation on a clean, dry and non-greasy base. The two methods below are intented for permanent bonding, which means the surface on which the kitchen wall panel is attached to may damage when removing the wall panel. We accept no liability for assembly errors.

 

The delivery includes 4 universal dowels, 4 screws, 1 hex key and 4 round clamps made of high-quality stainless steel. The wall spacing is 16 mm, the diameter of the clamp holders is 15 mm. Do not over-tighten the clamps as this could damage the print itself.

 

 

 

Apply the silicone to the back of the kitchen wall panel in a wavy manner. Position the wall panel where you want it, press it gently, and, if necessary, align it gently. To prevent moisture and dirt getting behind the wall panel, you can seal the gaps with silicone as well. 

 

 

Apply the foam tape to the back of the wall panel. Divide the area into several sections so there are enough fixation points. Please note it is difficult to remove the wall panel again once it has been attached to your wall.